Storm damage leaks
Leaks appearing after wind or hail
Metal almost never fails in the middle of a panel. It fails at the fasteners, where thermal movement backs screws out and flattens the neoprene washers underneath, and at seams where sealant has gone brittle. A screw standing proud by a couple of millimetres is an open hole, and there may be hundreds of them on a roof. Both failure modes are invisible from the ground and both are straightforward to fix — which is why a leaking metal roof rarely needs replacing.
Screven County sits in the eastern part of the state where the housing stock is the defining factor. Screven County has a wide spread of roof ages, from pre-war homes with original framing to recent subdivisions, and the leak profile differs sharply between them. Older properties leak at chimney flashing and valleys where decades of movement have opened joints that were never designed to flex. Newer ones leak at penetrations — boots, vents and skylights — where installation shortcuts show up five to ten years later. Summer storms bring wind and hail through on the same line that hits central Georgia, so both add storm damage on top.
Not always, but they went in on the same day and have had identical weather, so if a number have backed out the rest are on the same trajectory. Doing the whole roof at once usually costs less than returning twice.
That is the normal presentation. Fastener and seam failures are not visible from the ground and often not obvious from the roof either without checking each one. The panel itself is almost never the problem.
Leaks appearing after wind or hail
The metal at the roof edge
Airflow that stops condensation and ice dams
The capping along the roof peak
Bruising and granule loss
Full tear-off and new covering
You will get a straight answer on whether Screven County needs someone out today or whether it can wait — before anyone quotes you for anything.
Call (229) 235-1425